Unpacking And Checking Contents; Tools Needed; Unpacking - RIDGID SP6490 Operator's Manual

Unpacking and Checking Contents

Tools Needed

Medium Screwdriver
Adjustable Wrench
Phillips Screwdriver
Combination Square

Unpacking

WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete, and you have read and
understood the safety and operat-
ing instructions.
The Drill Press is shipped complete in one
box.
1. Separate all "loose parts" from packing
materials and check each item with
illustration and "Table of Loose Parts."
WARNING: To reduce the risk of
injury, if any parts are missing, do
not attempt to assemble the drill
press, plug in the power cord, or
turn the switch on until the missing
parts are obtained and installed
correctly.
2. Remove the protective oil that is applied
Combination Square Must be True
Draw Light
Line on Board
Along this Edge
Framing
Square
Should be no Gap or Overlap when Square
is Flipped Over in Dotted Position
3. Apply a coat of paste wax to the table
NOTE: Make certain all items are
accounted for before discarding any pack-
ing material.
10
to the table and column. Use any ordi-
nary household type grease and spot
remover.
WARNING: To reduce the risk of
fire or toxic reaction, never use gas-
oline, naptha or similar highly vola-
tile solvents to remove protective
oil.
and column to prevent rust. Wipe all
parts thoroughly with a clean dry cloth.
Straight Edge of
Board 3/4" Thick
This Edge Must be
Perfectly Straight