Specifications; Unpacking; Applications - RIDGID R84001 Operator's Manual

SPECIFICATIONS

Chuck .................................................................................................................................................3/8 in. (10 mm) Keyless
Motor ...................................................................................................................................................................... 18 Volt DC
Switch..............................................................................................................................................................Variable Speed
Gear Train ...................................................................................................................................................................2 Speed
No Load Speed ......................................................................................................................................... 0-400/0-1400/min.
Clutch .................................................................................................................................................................. 24 Positions
Charger Input ....................................................................................................................................... 120 V, 60 Hz, AC only
Charge Rate .......................................................................................................................................................... 20 minutes
Torque...................................................................................................................................................... Maximum 460 in.lb.

UNPACKING

INSTRUCTIONS
When unpacking the tool:
n Carefully remove the tool and accessories from the
box.
n Make sure that all items listed in the packing list are
included.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
3/8 in. (10 mm) Two Speed Drill
Charger
Battery Pack (2)
Auxiliary Handle
Double-ended Bit
Operator's Manual
Case

APPLICATIONS

You may use the two speed drill for the purposes listed below:
n Drilling in wood
n Drilling in ceramics, plastics, fiberglass, and laminates
n Drilling in both hard and soft metals
n Using driving accessories, such as driving screws with screwdriver bits
n Mixing paints
WARNING:
If any parts are missing do not operate the tool until
the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
7