Table of Contents
Advertisement
4.6
Reset button
Position
NOTICE
Loss of water and dust protection
If the cover is not mounted correctly, the device is not water and dust proof.
The Reset button ① is located behind the screw-down cover on the underside of the
housing.
①
Functions
The reset button has the following functions:
• Restart of the device
To restart the device, press the Reset button briefly.
Note
If you make changes to the configuration and restart immediately afterwards with the
reset button, the changes may be lost. If you restart the device using the WBM (menu
command "System > Restart") or using the CLI (command "restart" in the Privileged
EXEC Modus), the configuration changes are always retained.
• Loading new firmware
If the normal procedure with the "Load & Save" menu of Web Based Management is
unsuccessful, the reset button can be used to load new firmware. This situation can
occur if there is a power outage during the normal firmware update. For more detailed
information, refer to section "Upkeep and maintenance (Page 77)".
• Restoring the default parameters (factory defaults)
For more detailed information, refer to section "Upkeep and maintenance (Page 77)".
SCALANCE W1788-x / W1748-1
Operating Instructions, 03/2022, C79000-G8976-C484-05
PLUG slot with the reset button (covered)
Description of the device
4.6 Reset button
37
Advertisement
Table of Contents
