Description of the device
4.5 LED display
LED
F
P1
P2
R1
32
Color
Meaning
Flashing green and
Data transfer via the WLAN interface 1.
yellow
Access point mode:
Flashing yellow
With DFS (802.11h), the channel is scanned for one minute for
competing radar signals before the channel can be used for data
traffic.
Interval:
100 ms on / 100 ms
off
Off
No fault/error.
Red
The device is starting up or an error has occurred.
Flashing red
The bootloader waits in this state for a new firmware file that you
can download by TFTP.
Interval:
500 ms on / 500 ms
off
Flashing red
Firmware on PLUG:
The device is performing a firmware update or downgrade.
Interval:
2000 ms on /
200 ms off
Red
A competing radar signal was found on all enabled channels.
Simultaneous
R1 yellow flashing
Flashing green
The port LEDs flash for detection of device location.
The "LED flash" function is activated
•
•
Either with SINEC PNI
Or via the WBM page "Discovery and Set via DCP"
Operating Instructions, 03/2022, C79000-G8976-C484-05
SCALANCE W1788-x / W1748-1