Erasing - Sony DAT DTC-690 Operating Instructions Manual

1 2
)
7 £ 8
1
AUTO
START ID
2
RENUMBER
START ID
$ › 1 ¡ • ¶
START ID
START ID
SHIFT
RENUMBER
SKIP ID
END ID
Program
Numbers
Shifting Start IDs' and Program
Numbers Position
The start ID position may not coincide
exactly to the beginning of the selection,
especially when the portion between
selections is not clear. On such a tape, the
very beginning of the selection cannot be
located using the AMS function. If this
happens, you can shift the start ID and
program number position, however, you
cannot shift the position of the program
number 1.
1
Make sure that the AUTO indicator
is off, and that the safety tab of the
cassette is at the record-possible
position.
If the AUTO indicator is lit, press the
START ID AUTO button to turn off the
indicator.
2
Press the RENUMBER button
during playback or in the stop
mode.
The start ID and program number
position of the 2nd selection and the
succeeding selections, will be shifted
toward the head of the tape by about
0.3 of a second.
When program numbers are written
incorrectly, the renumber function
operates.

Erasing

Make sure that the safety tab of the
cassette is closed.
During playback, press the START ID
ERASE button while the program
number to be erased appears on the
display.
That program number is erased. The start
ID at the same position will also be erased.
The ERASE indicator flashes while the
program number is being searched for,
and the START ID indicator flashes while
the program number is being erased.
When the program number is
erased
Playback continues. The succeeding
program numbers remain unchanged. To
re-arrange the program numbers,
renumber them as described on page 36.
37