Table of Contents
Advertisement
4. Elbow connector
5. Seal
6. Nut
7. Rigid or flexible metallic feeder pipe
Put the supplied gasket between the pipe and the gas
supply ramp. Turn the pipe to the 1/2" gas supply
ramp.
1. Use a 22 mm spanner to tighten the nuts.
Keep the gas supply ramp in the correct position.
Do not apply force to the gas supply circuit.
WARNING
Do not use a flame to check for leaks!
2. Fully move the oven into the built-in cabinet.
WARNING
Do not squeeze the gas supply ramp and the pipe
when you move the oven into the built-in
cabinet.
3. Seal the connection correctly. Use a leak detection
to control it.
Adjustment to different types of gas
Let only an authorized person do the adjustment
to different types of gas.
If the appliance is set for liquid gas you can
change it to natural gas, with the correct
injectors.
The gas rate is adjusted to suit.
WARNING
Before you replace the injectors, make sure that
the gas knobs are in the Off position. Disconnect
the appliance from the electrical supply. Let the
appliance cool down. There is a risk of injury.
The appliance is set to default gas. To change the
setting always use the gasket sealing.
Oven injector replacement
1. Remove the bottom plate of the oven cavity (A) to
get access to the oven burner (B).
A
B
2. Release the screw (C), which keeps the burner in
position.
C
3. Carefully move the burner off the injector support
(D).
4. Slowly move it to the left side. Do not apply force to
the wire of the spark plug connector (F) and to the
thermocouple conductor (E).
5. Release the burner injector (D) with a 7 mm socket
spanner and replace it with a different one which is
necessary for the type of gas you use (see table in
«Technical Information» chapter).
Refer to «Technical information» chapter.
C
D
F
F
D
19
Advertisement
Table of Contents
