Table of Contents
Advertisement
Cleaning the Oven Door
Do not use metal scouring pads, wire brushes or
commercially available or abrasive powder cleansers to
clean the oven door as they could scratch the surface
and cause the glass to break.
In some oven models the door may be removed to
make them easier to clean, by proceeding as follows:
To mount the door, proceed in reverse order.
1
Open the door.
3
Close the door until it
fits in the two clamps.
CAUTION
Do not remove the safety pins at any time since
the hinge is taut and may cause injury. It would
also be impossible to mount the door without the
pins being in place.
To mount the door, hold it with both hands and insert
the hinges in the appropriate openings in the front of
the oven. Slowly open the door until it is fully open.
16
F
2
Turn the two clamps
(F) right round.
G
G
4
Holding the door at
the sides with both hands,
raise and remove the door
from the oven until the
hinges (G) have been
completely removed.
Cleaning the Large Inner
CAUTION
Be very careful when removing the inner glass,
as the oven door will close.
Instructions to remove / replace inside glass
panels. 90 cm oven
1
Open the oven door.
1
1
3
Squeeze point 1
located on the upper part
of both sides of the oven
door.
• The inside glass panels will now be loose and can
be easily cleaned with window cleaning liquid and a
soft cloth.
WARNING
If the door has not been blocked with the clamp
(N), please take care when removing the inside
glass panels as the oven door will close.
• Once clean, return the glass panels in the same
order so that the word TERMOGLASS can be read.
• Replace the upper clasp of the door, making sure
that the side tabs fit in point 1.
2
Fully rotate the two
clamps (N) to stop the
door from closing.
4
Continue squeezing
point 1 and pull out the
upper clasp of the door.
Advertisement
Table of Contents
