Table of Contents
Advertisement
view from the rear camera.
Using the "Video Input" wire with RCA jack (Yellow, not orange), display live view
from the front camera
Note: You need to enable front camera input. In the home menu (press
"SETTINGS" > "Camera" and select "Enable".
• Power supply to the camera
Using the "Rear Camera Output" wire (red/white), power the rear camera.
Using the "Aux Power Output" wire (red/purple), power the front camera. Press
on the front panel to turn on or off the front camera.
• Reverse trigger signal
Using the "Reverse Input" wire (purple/white), switch on the camera only when the
vehicle is put in reverse gear.
2.
Switch the unit to camera mode.
Press
to access the home menu, then use the function knob to select the "Camera"
icon. Or press
Audio Settings
This section helps you change the sound settings of this unit.
1.
In media play mode, press the function knob to access the audio menu.
2.
When audio menu is displayed, rotate the function knob to navigate the menu.
Rotate the function knob to make selection or adjust values. Press the function knob to
enter a sub-option or confirm the selection.
3.
After the settings is made, the menu will automatically exit five seconds of button
inactivity.
• BAS: Change output level for bass sound.
• TRE: Change output level for treble sound.
• BAL: Adjust left-to-right speaker output balance.
• FAD: Adjust front-to-rear speaker output balance.
• EQ: Select a preset sound mode (a preset equalizer setting) or turn off the preset.
• LOUD: Enable or disable loudness function. Enabling will boost output level of low and
high frequencies.
to quickly access camera mode.
15
), go to
Advertisement
Table of Contents
