Operating Instructions; Controls On Display Unit; Display Panel - Raymarine 465 Instruction Manual

Raymarine fishfinder instruction manual 465
Table of Contents

Advertisement

3 – Operating Instructions
In this section of the manual, we will explain how to operate the unit.
(Setup instructions are included in the next section.) Below is a drawing
of the display unit.
Display
area
Controls on Display Panel
The FishFinder is designed to be easy to use while the boat is moving.
You can steady your hand by gripping the right side of the display with
the fingers of your right hand. This will allow you to use your right thumb
to press the buttons on the display.
Notice that some of the buttons can be used in two ways. They do one
job during a normal display, and a different job when you are setting up
the unit. In this section, we will use symbols like this –
to indicate the buttons on the front of the unit.
PWR
This button turns the power on and off.
To turn on the power – Press once to turn the power on.
To enter the Lamp/Contrast Menu – To bring up the
Lamp/Contrast Menu in any operating mode, press the
PWR
To turn off the power – If you press and hold the button,
the display will say "Powering Off." If you hold the button for
more than 3 seconds, the display unit will switch off.

Operating Instructions

PWR
F I S H F I N D E R
SETUP
ZOOM
BOT
LOCK
465
key for a moment, then release it.
Power button
Page control
pad
Setup button
Clear button
CLEAR
Zoom button
A-SCP
A-Scope button
Bottom Lock
button
PWR
Fig. 3-1
Display
Panel
and
SETUP
25

Advertisement

Table of Contents
loading

Table of Contents