Table of Contents
Advertisement
How to use as PC Monitor
1. Turn on the PDP and press
2. Use
to select RGB1(Analog) and then press
(If the PC output is set to Digital, select RGB2(Digital).)
3. This PDP does not support Plug & Play function. When setting the PDP, select default.
4. Set the PC video output mode to VGA (640×480)/ SVGA (800×600)/ XGA (1024×768). In the
mode higher than SXGA (1280×1024), "Out of Range" message appears. Be sure to change
your PC video format to less than XGA mode. (Please refer to page 51 for the modes that PDP
supports)
on the remote controller.
.
2 3
Advertisement
Table of Contents
