Display Messages - Casio EXILIM EX-FH20 User Manual

Display Messages

ALERT
Battery is low.
Camera not in
standby.
Re-frame the image.
Cannot find the file.
Cannot register any
more files.
Card ERROR
Check connections!
Files could not be
saved because
battery is low.
Flash cool down...
Open the flash unit.
Flash not possible.
The camera's protection function may have activated
because camera temperature is too high. Turn off the
camera and wait until it cools down before trying to use it
again.
Battery power is low.
Move Out CS or Move In CS framing could not be
performed for some reason, and so the camera cannot go
into auto record standby. Perform the framing operation
again (page 71).
The image you specified with the slideshow "Images"
setting cannot be found. Change the "Images" setting (page
95) and try again.
You are attempting to save a user BEST SHOT scene in
the "SCENE" folder when the folder already contains 999
user scenes.
There is something wrong with the memory card. Turn off
the camera, remove the memory card and then reload it
into the camera. If this message re-appears when you turn
the camera back on, format the memory card (page 135).
IMPORTANT!
• Formatting a memory card deletes all its files. Before
formatting, try transferring recoverable files to a
computer or some other storage device.
You are attempting to connect the camera to a printer while
the camera's USB settings are not compatible with the USB
system of the printer (page 106).
Battery power is low, so an image file could not be saved.
The flash is disabled for a short while to protect the flash
unit after consecutive operations during Flash CS. You will
be able to resume using the flash after this message
disappears.
The flash needs to be fired by the flash unit is not open.
Press
ð (Flash up)
Battery power is too low to fire the flash. Replace or charge
the batteries as soon as possible.
165
to open the flash unit.
Appendix