Solving Problems; Solving Network Connection Problems; Solutions When You Cannot Find Connected Projectors (Wired) - Epson vs 230 Operation Manual

Solving Problems

Solving Network Connection Problems

Solutions When You Cannot Find Connected Projectors (Wired)

Downloaded from ManualsNet.com search engine
See the following sections to check for solutions to problems you may have using the Epson Projector
Management software.
Solving Network Connection Problems
Solving Monitoring and Controlling Problems
Solving Firmware Updating Problems
Try these solutions depending on your network environment.
Solutions When You Cannot Find Connected Projectors (Wired)
Solutions When You Cannot Find Connected Projectors (Wireless)
Parent topic: Solving Problems
When you cannot find the projector over a network using a wired connection, try the following solutions.
If you cannot resolve the problem, contact your network administrator.
• Connect the network cable securely.
Note:
• Use a commercially available 100BASE-TX or 10BASE-T LAN cable.
• To prevent malfunctions, use a category 5 or higher shielded LAN cable.
• Check the projector's network settings.
• Set DHCP to Off. When DHCP is set to On, it may take some time to enter LAN standby status if an
available DHCP server is not found.
• Set the IP address, the subnet mask, and the gateway address for the projector correctly.
• Close the network settings menu on the projector.
• Check the computer's network settings.
• Enable LAN settings on your computer.
• Turn off the firewall. If you do not want to turn it off, register the firewall as an exception. Make the
necessary settings to open the port. The port used by this software is "56181" (TCP).
55