Rear wheel
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1. Axle nut
2. Remove the brake pedal free play
adjusting nut, and then discon-
nect the brake rod from the brake
camshaft lever.
Periodic maintenance and adjustment
EAU25081
1
EAU56610
EWA10822
(a)
1. Brake pedal free play adjusting nut
2. Brake rod
3. Turn the drive chain adjusting
plate on each side of the swing-
arm fully in direction (a).
1. Rear wheel
2. Drive chain
4. Lift the rear wheel off the ground
2
5. Remove the axle nut, and then pull
6. Push the wheel forward, and then
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
7. Remove the wheel.
To install the rear wheel
1. Insert the wheel axle from the left-
TIP
Make sure that the drive chain adjust-
ing plates are installed with the
punched sides facing to the outside
and that the slot in the brake shoe plate
fits over the retainer on the swingarm.
7-30
according to the procedure on
page 7-28.
the wheel axle out.
remove the drive chain from the
rear sprocket.
hand side.
7