TIP
If a torque wrench is not available
when installing a spark plug, a good
estimate of the correct torque is 1/4–
1/2 turn past finger tight. However, the
spark plug should be tightened to the
specified torque as soon as possible.
Periodic maintenance and adjustment
Engine oil
The engine oil level should be checked
before each ride. In addition, the oil
must be changed at the intervals spec-
ified in the periodic maintenance and
lubrication chart.
To check the engine oil level
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
tion. A slight tilt to the side can
result in a false reading.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Wait a few minutes until the oil set-
tles, remove the engine oil filler
cap, wipe the engine oil dipstick
clean, insert it back into the oil fill-
er hole (without screwing it in), and
then remove it again to check the
oil level. WARNING! Never re-
move the engine oil filler cap af-
ter
high-speed
otherwise hot engine oil could
spout out and cause damage or
injury. Always let the engine oil
cool down sufficiently before re-
7-8
moving the oil filler cap.
EAUW043B
NOTICE: Do not operate the ve-
hicle until you know that the en-
gine oil level is sufficient.
1. Engine oil filler cap
TIP
The engine oil should be between the
minimum and maximum level marks.
operation,
[EWA17640]
[ECA10012]
7