Yamaha TTR 125 2020 Owner's Manual page 46

Periodic maintenance and adjustment
6. Clean the sponge material with
solvent, and then squeeze the re-
maining solvent out. NOTICE: To
avoid damaging the sponge ma-
7
terial, handle it gently and care-
fully, and do not twist it.
7. Apply oil of the recommended
type to the entire surface of the
sponge material,
squeeze the excess oil out.
TIP
The sponge material should be wet but
not dripping.
Recommended oil:
Yamaha foam air filter oil or other
quality foam air filter oil
8. Install the sponge material onto
the frame, place the air filter ele-
ment in the original position on the
guide, and then tighten the wing
nut.
1. Air filter sponge material
[ECA15102]
2. Washer
3. Nut
9. Insert the air filter element into the
and then
air filter case. NOTICE: Make
sure that the air filter element is
properly seated in the air filter
case. The engine should never
be operated without the air filter
element installed, otherwise the
piston(s) and/or cylinder(s) may
become
[ECA10482]
10. Install the air filter case cover by
11. Install the panel.
Checking and cleaning the air filter
case check hoses
1. Air filter check hose plug
2. Air filter check hose
excessively worn.
7-11
installing the band.
1. Check the air filter case check
hoses for accumulation of dust or
water.
2. If dirt or water is visible, remove
the hoses, clean them, and then
install them.
1
2