B Regulatory Compliance Notices; Regulatory Compliance Identification Numbers; Product Specific Information; Regulatory Compliance Label Location - HP StorageWorks Ultrium 960 User's And Service Manual

B Regulatory compliance notices

Regulatory compliance identification numbers

For the purpose of regulatory compliance certifications and identification, this product has been
assigned a unique regulatory model number. The regulatory model number can be found on the
product nameplate label, along with all required approval markings and information. When
requesting compliance information for this product, always refer to this regulatory model number.
The regulatory model number should not be confused with the marketing name or model number of
the product.

Product specific information

Regulatory Model Number:
FCC and CISPR classification:

Regulatory compliance label location

The Regulatory Compliance label for the HP StorageWorks 1/8 Tape Autoloader is located on the
bottom of the autoloader. To view this information, carefully turn the autoloader until the regulatory
compliance label is visible.

Federal Communications Commission notice

Part 15 of the Federal Communications Commission (FCC) Rules and Regulations has established
Radio Frequency (RF) emission limits to provide an interference-free radio frequency spectrum. Many
electronic devices, including computers, generate RF energy incidental to their intended function
and are, therefore, covered by these rules. These rules place computers and related peripheral
devices into two classes, A and B, depending upon their intended installation. Class A devices are
those that may reasonably be expected to be installed in a business or commercial environment.
Class B devices are those that may reasonably be expected to be installed in a residential
environment (for example, personal computers). The FCC requires devices in both classes to bear a
label indicating the interference potential of the device as well as additional operating instructions
for the user.

FCC rating label

The rating label on the device shows the classification (A or B) of the equipment. Class B devices
have an FCC logo or FCC ID on the label. The HP StorageWorks 1/8 Tape Autoloader is a Class B
device (see <cross-reference>Class B equipment).

Class B equipment

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
BRSLA-0203
Class B
Ultrium 960, Ultrium 448, Ultrium 460, Ultrium 230, DLT VS80, SDLT 320 71