Installing The Autoloader Into A Rack (Optional) - HP StorageWorks Ultrium 960 User's And Service Manual

Installing the autoloader into a rack (optional)

The autoloader fits all standard 19-inch racks, taking up 2U of space. To install the autoloader into
a rack, install the mounting brackets on both sides of the autoloader and the rails in the selected
rack location.
To install the autoloader:
1. Use a medium-sized Phillips screwdriver to remove the two screws near the front on each side of
the autoloader cover (see
2. Using the screws you removed in step 1, secure one mounting bracket (from the rack mount kit)
to each side of the autoloader as shown in
Figure 5 Installing mounting brackets (left side shown)
3. Using the screws and clip nuts from the rack mount kit, secure one rail to each side of the rack in
the location in which you plan to install the autoloader.
• Be sure to secure both the front and rear of each rail to the rack. The rails extend to fit a
variety of rack depths.
16 Installing the autoloader
Figure 5).
Figure 5.