Panasonic CF-Y2 Operating Instructions Manual page 44

Hard Disk Backup Function
44
7 Select how to divide the hard disk from the menu.
<To create a backup area and enable the backup function without dividing the hard disk>
Select [1].
[At the time of purchase]
The usable hard disk area
<To create a backup area and divide hard disk into two partitions, for OS and data>
Select [2], enter the partition size (GB), and press Enter .
• You can cancel this operation by pressing 0 .
• The data partition size will be the maximum settable size less the number entered above.
The maximum settable size will differ depending on models.
[At the time of purchase]
The usable hard disk area
8 At the confirmation message, press Y .
The backup area is then created.
9 When the message [You must reboot in order to enable the Backup function.] appears, remove
the Product Recovery DVD-ROM, and press any key to restart the computer. The computer is
restarted, then the backup process will begin.
10 When the message [[Backup] is complete] appears, press Ctrl + Alt + Del to restart the
computer.
CAUTION
Do not press Ctrl + Alt + Del until the message is displayed.
11 After logging on to Windows, a message will appear advising that a new device has been
installed and that the computer must be restarted to enable the settings. Select [Yes] to restart
the computer.
NOTE
The [Boot] menu in the Setup Utility is set to start up from the DVD-ROM & CD-R/RW
drive. Change this setting if necessary.
The next time the backup or restore functions are executed, follow the procedure for [Backing
Up and Restoring Data] (
[After the backup area is created]
Can be accessed from
Windows (One partition).
[After the backup area is created]
Can be accessed from
Windows (Two partitions).
page 45).
The backup area
Cannot be accessed
from Windows.
The backup area
Cannot be accessed
from Windows.