Residual Risks; Before Use; Appliance Position; Assembling/Disassembling The Sanding Table With Sanding Table Holder - Parkside PTSG 140 A1 Translation Of The Original Instructions

■ Check that all moving parts work properly with-
out jamming and whether parts are damaged.
All parts must be properly fitted and meet all
the conditions to ensure the proper operation of
the power tool. Damaged safety devices and
parts must be properly repaired or replaced by
a specialist workshop unless otherwise indicat-
ed in the instructions.
■ Damaged switches must be replaced at an
authorised customer service centre.
■ Do not use any power tools that you cannot
switch on and off with the power switch.
CAUTION! The use of other tools and accesso-
ries could lead to an increased risk of personal
injury for you.
■ Have your power tool repaired by a qualified
electrician! This power tool complies with all
relevant safety regulations. Repairs may only
be performed by a qualified electrician using
original spare parts. Failure to do so could put
the user at risk of accidents.

Residual risks

Even if you operate this power tool properly, there
will still be residual risks. The following risks can
occur in relation to the power tool's design and
structure:
▯ Lung damage, if no suitable breathing protec-
tion is worn.
▯ Hearing damage, if no suitable hearing protec-
tion is worn.
▯ Damage to health caused by vibrations if the
appliance is used for extended periods or is
not properly used and maintained.
PTSG 140 A1
WARNING!
■ The power tool creates an electromagnetic
field during operation. This field can, in cer-
tain circumstances, impair active or passive
medical implants. To reduce the risk of fatal
injuries, we recommend that people with
medical implants consult their doctor and the
manufacturer of the medical implant before
operating this machine.

Before use

CAUTION!
■ This appliance is not designed for continuous
operation.
–
If the appliance overheats, switch it off and
allow it to cool down.

Appliance position

■ The appliance can be set horizontally or verti-
cally.
♦ Fix the supplied screw clamp
clamp mounting
the appliance tipping over.
Assembling/disassembling the
sanding table with sanding table
holder
♦ Undo and remove the hex socket screw
the plain washer
table holder .
♦ Now pull the sanding table holder
with the sanding table
♦ To refit the sanding table
table holder with the sanding table
into the normal position.
♦ After this, reinsert the hex socket screw
the plain washer
using the screw
to a table edge to prevent
underneath the sanding
together
off towards the front.
, push the sanding
back
and tighten the screw.
GB │ CY │
and
and
5 ■