Onkyo TX-DS595 Instruction Manual page 36

Using remote controller
ON
RETURN
ENTER/Cursor
button
C H
DISC
DISC
TOP MENU
AUDIO
AUDIO
ANGLE
TV / VCR
ANGLE
RANDOM
REC
DVD
V 1
V 3
STEREO
1
SURR
4
SP A
7
DISPLAY
+10
-- / ---
HOME THEATER CONTROLLER
36
STDBY
DVD MODE
SETUP
VOL
VOL
MENU
MUTING
MUTING
SUBTITLE
LEVEL
SUBTITLE
DVD
OPEN / CLOSE
operation
buttons
C D
V 2 T 1 T 2
V 4 TUN P H
DIRECT DSP
2 3
Numeric keys
A.ST DSP
5 6
SP B
Re-EQ
8 9
DIMMER ZONE 2
0 SEARCH SEARCH
ENTER
RC-447M
Controlling an Onkyo DVD player
The z connector of the Onkyo DVD player must be connected to
the TX-DS595 (see page 13).
1. Press the DVD MODE button.
The DVD MODE button lights green.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Onkyo DVD player.
Operation buttons:
ON: Turns the DVD player on and off.
STDBY: Turns the DVD player off. (Some sets may not respond to
this button. In this case, use the ON button to put the DVD player in
the standby state.)
SETUP: Displays the menu.
: Moves the cursor.
ENTER: Confirms the selection.
RETURN: Return button
TOP MENU or MENU: Displays the menu screen(s) recorded on
DVD media.
DISC : Selects a disc in the DVD changer.
AUDIO: Press repeatedly to select an audio and/or language track
recorded on a DVD-Audio/Video.
ANGLE: Press repeatedly to select a camera angle when a DVD-
Video is recorded with multiple angle playback.
SUBTITLE: Press repeatedly to select one of the subtitle languages
recorded on a DVD-Video.
SEARCH: Press to find the specific section on a disc where you
want to start playback.
RANDOM: Press to start random playback.
: Chapter/Track down
: Chapter/Track up
: Play
: Stop
: Fast reverse
: Fast forward
: Pause
OPEN/CLOSE r: Open/close the disc tray
0, 1 to 9, +10: Numeric keys
You may also use the following buttons:
VOL : Adjusts the volume at the TX-DS595
MUTING: Activates the muting function at the TX-DS595
Note:
When operating an Onkyo DVD player directly with the remote
controller without connecting the z terminals, pre-programming is
necessary (see page 38).