Onkyo TX-DS595 Instruction Manual page 18

Connecting antennas
Connecting an FM outdoor antenna
Please make sure that you follow the considerations:
• Keep the antenna away from noise sources (neon signs, busy
roads, etc.).
• It is dangerous to put the antenna close to power lines. Keep it
well away from power lines, transformers, etc.
• To avoid the risk of lightning and electrical shock, grounding is
necessary. Follow item 14 of the "Important Safeguards" on
page 2 when you install the outdoor antenna.
ANTENNA
AM
FM
75
Connecting an AM outdoor antenna
An outdoor antenna will be more effective if it is stretched
horizontally above a window or outside.
• Do not remove the AM loop antenna.
• To avoid the risk of lightning and electrical shock, grounding is
necessary. Follow item 14 of the "Important Safeguards" on
page 2 when you install the outdoor antenna.
Outdoor antenna
ANTENNA
AM
FM
75
Note:
If you are using the TX-DS595 worldwide model in a region where
AM frequencies are delineated by 10-kHz steps, be sure to set the
AM Freq Step Setup setting accordingly (see page 32).
18
Directional linkage
Do not use the same antenna for both FM and TV (or VCR)
reception since the FM and TV (or VCR) signals can interfere with
each other. If you must use a common FM/TV (or VCR) antenna, use
a directional linkage type splitter.
Connecting the antenna cable to the 75/300 Ω
antenna adapter (For all models other than USA,
Canadian and European models)
Connecting the 300 Ω ribbon wire:
Loosen the screws and wrap the wire around these screws. Then
tighten the screws with a screwdriver.
Connecting the coaxial cable:
1. With your fingernail, or a small screwdriver, press the
2. Remove the transformer wire A from slit B and insert
3. Prepare the coaxial cable as shown in the diagram.
4. Connect the 75/300 Ω antenna adapter to the coaxial
(Indoor)
AM loop antenna
5. Reinstall the cover.
To receiver
stoppers of the 75/300 Ω antenna adapter outward
and remove the cover.
it into slit C.
cable.
1. Insert the end of the cable.
2. Clamp it in place with pliers.
1 2
Slit C
To TV (or VCR)
Outdoor
antenna
300 Ω
ribbon wire
3, 4
6 3 6
mm mm mm
Slit B
15mm
5/8"
Wire A