Using The Remote Controller - Onkyo TX-DS575x Instruction Manual

Using the remote controller

Overview
When you use a remote controller, typically you press one of the MODE buttons that corresponds to the device you wish to control, then
press the operation buttons. For example, if you wish to control the TX-DS575X from a remote controller, first press the MODE AUDIO but-
ton, then press an appropriate operation button. To control a CD player, press the MODE CD button, then press an appropriate operation but-
ton.
First, press the desired MODE button to make sure that the TX-DS575X is set to a correct mode.
SEND/LEARN
indicator
ON
MODE AUDIO
ON
SLEEP
MODE
AUDIO
DISPLAY
CH +/-
SP A/B
DIMMER
Using the RC-392M to control each device
Turning the power on and off to the TX-DS575X
Note:
Before operating the RC-392M, turn on the POWER switch on the
TX-DS575X so that the unit enters standby mode.
STNBY
1. Press the MODE AUDIO button.
2. Pressing the ON button will power on.
Pressing the STNBY button will power standby.
SEND/LEARN indicator
This indicator acts as a guide when commands are programmed
into or sent by the remote controller. It also warns the user when
an error is made or battery power is low.
Controlling the TX-DS575X
1. Press the MODE AUDIO button.
2. Press the desired operation button.
Shaded buttons in the figure are the operation buttons used to
control the TX-DS575X.
STNBY
SLEEP
ON/STNBY
LIGHT
DISPLAY
VOL q/u
CH +/–
INPUT SELECTOR
Listening mode (STEREO/DSP√/DSP®/SURROUND)
SP A/SP B
CH SEL
DIMMER
VOL
LEVEL +/–
TEST
TEST
MUTING
LIGHT
MUTING
INPUT
SELECTOR
Listening
mode
LEVEL +/-
CH SEL
: Sleep function
: Power on/standby
: Changing the display
: Adjusting the volume
: Tuner preset number increment/decrement
: Changing Listening mode
: Switching between Speakers A and B
: Selecting a speaker
: Adjusting the brightness of the display
: Adjusting the speaker levels
: Test tone
: Muting
: Iluminating the buttons.
31