Recording A Source - Onkyo TX-DS575x Instruction Manual

Recording a source

You can record analog Audio, but not digital audio. Make sure that you have made a correct analog connection.
You cannot record the source connected to MULTI CHANNEL INPUT jack.
If you select another device as the input source during recording, the input signal from that device will be recorded.
You cannot record audio source along with the surround effects.
1
PTY/TP
STANDBY/ON
STANDBY
POWER
ON OFF
A SPEAKERS B
DISPLAY STEREO
PHONES
MULTI CH DVD VIDEO 1 VIDEO 2
INPUT
1·3
Tape deck
(TAPE)
2
DVD VIDEO 1 VIDEO 2
FM AM PHONO
1
PTY/TP
STANDBY/ON
STANDBY
POWER
ON OFF
A SPEAKERS B
DISPLAY STEREO /DTS SURROUND
PHONES
DVD VIDEO 1 VIDEO 2
MULTI CH
INPUT
2
1·3
VCR
(VIDEO 1)
2
VIDEO 2 VIDEO 3
2
FM MUTE / DIGITAL/ SP / SYS MASTER VOLUME
MEMORY MODE DOWN TUNING UP ANALOG SETUP CH LEVEL
MODE
PRESET / MODE ADJ
DOW N UP
ENTER / SCAN
LISTENING MODE
LATE NIGHT / LFE LEVEL
/DTS SURROUND 5 CH STEREO DSP FRONT EFFECT Re -EQ CONTROL
BASS TREBLE
VIDEO 3 TAPE FM AM PHONO C D
AV RECEIVER TX-DS575X
3
Turntable
CD player
VCR, VDP
DVD
VIDEO 3
C D
MASTER VOLUME
FM MUTE / DIGITAL/ SP / SYS
MEMORY MODE DOWN TUNING UP ANALOG SETUP CH LEVEL
MODE
PRESET / MODE ADJ
DOW N UP
ENTER / SCAN
LISTENING MODE LATE NIGHT / LFE LEVEL
5 CH STEREO DSP FRONT EFFECT Re -EQ CONTROL
BASS TREBLE
VIDEO 3 TAPE FM AM PHONO C D
TX-DS575X
AV RECEIVER
1·3
VDP, DVD player
(VIDEO 2, VIDEO 3)
DVD
or
Recording an audio source
Make all connections between the tape deck and the receiver as
shown in the "Audio equipment connections" diagram (page 6).
1. Insert a blank tape into the tape deck.
2. Press the input selector button for the source you want to
record.
If you select DVD, VIDEO 1, VIDEO 2 or VIDEO 3, only the
audio will be recorded.
If you select FM or AM, set the tuner to the station you want to
record.
3. Set the tape deck in recording mode. Start playing the
source.
Set the proper recording level using the controls on the tape
deck.
Please read the corresponding instruction manuals for more
information on how to operate the corresponding equipment.
Recording data from a video disc player (or a
video camcorder) to VCR
Video disc programs can be recorded onto a VCR (VIDEO 1).
1. Load a disc in the video disc player or DVD player, and
insert a blank tape in the VCR (VIDEO 1).
2. Press the VIDEO 2, VIDEO 3 or DVD button.
3. Start playing the video disc player and recording on the
VCR.
Refer to the Video equipment connections section on the page 7.
29