Muting The Receiver (Remote Controller Only); Using Headphones; Setting The Display Brightness; Using The Sleep Timer (Remote Controller Only) - Onkyo TX-8522 Instruction Manual

TX- 85228222_En.book 22 ページ ２００６年５月４日 木曜日 午前１１時５１分
Enjoying Audio Sources —Continued
PHONES
Muting the receiver
(remote controller only)
You can temporarily mute the output of the receiver.
1
Press the remote controller's
[MUTING] button.
Receiver
The receiver is muted.
To unmute the receiver, press the
[MUTING] button again.
Note:
The Mute function will be cancelled if
the remote controller's VOLUME
buttons are pressed or the receiver is set
to Standby.

Using Headphones

You can connect a pair of stereo headphones (1/4-inch
phone plug) to the receiver's PHONES jack for private
listening.
Notes:
• Always turn down the volume before connecting your
headphones.
• Sound output from speakers is not turned off even if
(when) the headphones plug is inserted in the
PHONES jack. To turn off or on the sound output from
speakers, use the SPEAKERS A and SPEAKERS B
switches.
22
SLEEP
DIMMER (TX-8522 Other than
North American
model)
DIMMER
(TX-8222)

Setting the Display Brightness

You can adjust the brightness of the display.
1
Receiver
Remote
controller
Using the Sleep Timer
(remote controller only)
With the sleep timer, you can set the receiver so that it
turns off automatically after a specified period.
1
Remote
controller
To cancel the sleep timer, press the [SLEEP] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [SLEEP]
button. Note that if you press the [SLEEP] button while
the sleep time is being displayed, you'll shorten the sleep
time by 10 minutes.
DIMMER
MUTING
Press the remote controller's
[DIMMER] button repeatedly to
select: dim, dimmer, or normal
brightness.
Alternatively, you can use the
[DIMMER] button on the TX-8522
(other than North American model) and
TX-8222.
Press the remote controller's
[SLEEP] button repeatedly to
select the required sleep time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been set,
as shown. The specified sleep time appears
on the display for about 5 seconds, then the
previous display reappears.
SLEEP indicator