Software Installation - Nortel NN42030-102 User Manual

Software installation

This section describes how to install, upgrade, and uninstall the Nortel
Multimedia Communication Client 3100 (MCC 3100) for Nokia on a
supported Nokia device. There are two ways to install or upgrade the
MCC 3100 for Nokia: from a computer or over the air.
Before you install or upgrade the MCC 3100 for Nokia software from a
computer, ensure that your Nokia device and your PC are connected
using a Universal Serial Bus (USB) cable and ensure that Nokia PC Suite
software is installed on your PC.
Note 1: Ensure that your device has the correct date and time.
Note 2: In some cases, it is necessary to remove the existing
software components prior to performing an upgrade. Check with
your system administrator or read the release notes before
proceeding with an upgrade.
Note 3: If you are upgrading from an earlier release, you must
perform an initial software installation, not an upgrade. After
reinstalling the software, change the MCG 3100 address on the
Systems Settings screen if instructed to do so by your system
administrator.
Note 4: If you wish to use Hypertext Transfer Protocol Secure
(HTTPS) with certificates, you should install the certificate prior to
installing the MC 3100 client.
Use the following procedures to install, upgrade, and uninstall the
MCC 3100 for Nokia software.
• "Installing the MCC 3100 for Nokia software from a computer"
on page 20
• "Installing the MCC 3100 for Nokia software over the air" on
page 21
• "Upgrading the MCC 3100 for Nokia software from a computer"
on page 23
Nortel Mobile Communication Client 3100 for Nokia User Guide
Software installation
19