Table of Contents
Advertisement
Maintenance
2.
Place the handle in the closed position, refer
to Opening the Discharge Gate in the
Operation section.
3.
Unlock the Operator Controlled Discharge
accessory assembly and pivot it away from the
mower deck.
4.
Adjust the cable nuts located behind and
under the linkage cover (see Figure 14). Turn
nuts until desired gate position is achieved.
5.
If more adjustment is necessary, remove the
cotter pin shown in Figure 14.
6.
Remove the pivot adjuster from the gate pivot.
7.
Loosen the lock nut.
8.
Thread the pivot adjuster forward or backward
until desired result is achieved.
9.
Tighten the lock nut and reinstall the pivot
adjuster into the gate pivot and secure with
the cotter pin.
10.
Repeat steps 4 through 9 until the discharge
gate is properly adjusted.
16
Advertisement
Table of Contents
