Table of Contents
Advertisement
Assembly
9. Install bearing cage assy. with the
new shim pack calculated as above.
• Tighten bearing cage mounting bolts
to the torque of 75 - 90 ft-Lb
10. Heat the ring gear in a water/ oil
bath to about :l70⁰f(80⁰c) for 15
minutes.
11. Install the ring gear on flange half
Immediately aligning mounting holes.
Figure 38.
12. Install mounting bolts and nuts.
√ Tighten the nuts to the torque of 70-
80 ft.lbs
13. Install the bearing cones on both
Diff. cases.
14. Install spider, side gear, diff. pinions
and thrust washers into flange half.
√ Install plain half aligning match
marks Figure 39.
√ Torque tighten the diff. case bolts to
85-100 ft.lbs
30
Figure 38
Flange Case
Half
Figure 39
Ring Gear
Bolt Head
against gear
Plain
Case Half
Match
Marks
Advertisement
Table of Contents
