Table of Contents
Advertisement
General Information
Use of Dri-Loc Fasteners and
Meritor Liquid Adhesive 2297-
C-3747 or Loctite 277
Install New Dri-Loc Fasteners
1. Clean the oil and dirt from threaded
holes. There is no special cleaning
required.
2. Assemble parts using the new Dri-
Loc fasteners.
!
CAUTION:
Do not apply adhesives or sealants on
new Dri-Loc fasteners or in the
threaded holes. If other adhesives or
sealants are used, the new Dri-Loc
adhesive will not function correctly.
Tighten the Dri-Loc fasteners to the
required torque value for that size
fastener. There is no special procedure
or torque value required. See the torque
T
chart
NOTE:
There is no drying time required for
Dri-Loc fasteners.
Install Old Dri-Loc Fasteners Using
Meritor Liquid Adhesive 2297-C-
3747 or Loctite 277:
:
1. Clean the oil and dirt from threaded
holes. There is no special cleaning
required and it is not necessary to
remove the old Dri-Loc adhesive
from the threads.
2. Apply four or five drops of Meritor
Liquid Adhesive or Loctite 277 to the
threaded holes ONLY. Make sure the
adhesive is on the threads. Figure21.
!
CAUTION:
Do not apply adhesive to the fastener
threads. Air pressure in the hole will
push the adhesive out as the fastener
is installed.
3. Tighten the fasteners to the required
torque value for that size fastener.
There is no special procedure or
torque value required. See the
torque chart
Figure 21
T
13
Advertisement
Table of Contents
