Table of Contents
Advertisement
74 | Crystal Imager | Advanced Operation (key-operator mode)
2. Press the Confirm key to continue.
The 'Printer IP address' screen is displayed:
If the IP address has already been assigned, it will be shown on the display.
3. Press the up/down arrow keys to increment/decrement the numbers.
Press the left/right arrow keys to move through the fields. Press the
Confirm key to store the data.
Example 1: if the IP address is 120.000.120.120, then the data entry
should be as follows:
Example 2: if the IP address is 120.0.120.120, then the data entry should
be as follows:
4. Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
The 'Netmask' screen is displayed:
If the netmask has already been assigned, it will be shown on the display.
5. Enter the netmask by means of the arrow keys.
3830B EN 20210520 0952
Note: When no DHCP server is available and when the IP
address of the printer has never been set, the printer IP
address will be set to the APIPA address 169.254.10.10.
Note: Note that blank spaces will be ignored (see examples
below).
250.250.250.250
Note: When no DHCP server is available and when the
subnet mask of the printer has never been set, the printer
subnet mask will be set to the APIPA address 255.255.0.0.
250.250.250. 0
Advertisement
Table of Contents
