Table of Contents
Advertisement
2-2. Replacement of Hard Disk Drive
(7) Unscrew the six screws.
n
Never hit the hard disk drive with a screw
driver.
(8) Lift up the HDD unit and remove it.
n
Place removed the HDD unit gently on the
HDD cushion.
For lower part (HDD unit 3 or 4);
n
First of all, remove the upper HDD unit on HDD
unit to be removed.
(The figure shows the removal of HDD unit 3.)
(1) Remove the SCSI cable from wire holders 1.
(2) Disconnect the two 68-pin connectors by
holding each end of it.
n
Never pull the covered wire.
(3) Open wire holder 2 and free the SCSI cable.
(4) Open wire holder 3 and free the SCSI cable
and POWER harness.
(5) Free the cable and harness described in (4) as
shown in the figure with bending the aero-
plate lightly.
(6) Move the SCSI cable to the opposite side of
the HDD unit 3 as shown in the figure with
bending the aeroplate lightly.
n
Place the SCSI cable gently so that the hard
disk drives do not receive any shock.
(7) Remove the HDD unit by the same way as
(5) to (8) of upper HDD unit removal.
4. Replacement of hard disk drive
Refer to Section 2-2-3.
2-6 (E)
PWH3 x 5
PWH3 x 5
HDD unit
68-pin connectors
SCSI cable
Wire holder2
PWH3 x 5
POWER harness
SE harness
UNIT harness
IF-715 board
Aeroplate
Wire holder4
Wire holder3
HDD unit 3
Wire holders1
BKNW-116
Advertisement
Table of Contents
