Table of Contents
Advertisement
Input D AC Voltage Accuracy (HF) and Bandwidth Test
The test steps for channel C are only for the 4-channel models.
To test the Input D high frequency automatic scope ac voltage measurement accuracy and the
bandwidth:
1. Connect the Test Tool to the 5502A. See
2. Select the Test Tool setup:
a. Recall the setup (see
select SETUP, press
setup.
P
b. Press
J
c. Press
to select autoranging (AUTO in upper right LCD edge).
j
k
d. Use
and
lock the Input C sensitivity range on 500 mV/div.
l
e. Use
to move the Input D trace zero to the center grid line.
T
f.
Press
3. Set the 5502A to source a sine wave and to the first test point in
4. Observe the Input D reading and check that it is within the range shown under the
appropriate column of
When you are finished, set the 5502A to Standby.
Standard Test Tool
E
, select the setup name, and press
2
, then press
to change the sensitivity range to select manual sensitivity ranging and
1
and use
Table
10.
Note
Figure 9
Setup). Press
(READING...) and select READINGS 4 on D | V ac.
to select Input C as trigger source.
ScopeMeter® Test Tool
Performance Verification
S
2
,
(RECALL) and
E
to recall the
Table
10.
27
Advertisement
Table of Contents
