Set Date And Time Manually - Motorola D1110 Series User Manual

2. Insert the 2 x AAA NiMH batteries supplied into the handset. Then
slide the compartment cover into place.
3. Place the handset on the charger to charge for at least 24 hours.
When the handset is fully charged the
fully charged.
4. When the handset is fully charged after 24 hours, plug the telephone
line cord from the large base into the telephone wall socket.
IMPORTANT
Warning! Use only rechargeable batteries. If non-rechargeable batteries
WRONG BATTERY
are used will be displayed and charging will be stopped.
Please replace with rechargable batteries.
BATTERY LOW WARNING
If the icon shows a red segment in the display, you will need to
recharge the handset before you can use it again.
During charging, the icon will scroll in the display.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give about 10 hours talk
time or 100 hours standby time on a single charge.
Note that new batteries do not reach full capacity until they have been in
normal use for several days.
To keep your batteries in the best condition, leave the handset off the
base for a few hours at a time.
Running the batteries right down at least once a week will help them last
as long as possible.
The charge capacity of rechargeable batteries will reduce with time as
they wear out, giving the handset less talk/standby time. Eventually they
will need to be replaced.
After charging your handset for the first time, subsequent charging time
is about 6–8 hours a day. Batteries and handset may become warm
during charging. This is normal.
Getting started
Date and time
Providing you have subscribed to your network's Caller Display service,
the date and time is set automatically for all handsets when you receive
icon will indicate that it is
your first call.
The date and time is recorded with each answer machine message you
receive.
If you do not have a Caller Display service you can set the date and time
manually.

Set date and time manually

1. Press
2.
3. Enter the date using the format DD/MM/YY e.g. 01 09 08 for 1st
4. Press
Your D1111 is now ready for use.
u d
Menu Clock & Alarm
and scroll or to
Date & Time Select
is highlighted. Press
September 2008. Enter the time in 12 or 24 hour time format. Press
Save
. To change the Time Format see page 22.
>
Back
or until you return to standby.
Select
then press .
.
7