Installing The Boot Manager - Nokia IP350 Appliance Installation Manual

7
Using the Boot Manager

Installing the Boot Manager

The boot manager is installed at the factory; you should not need to re-install
it. If you should need to re-install the boot manager, contact the appropriate
Nokia customer support site listed in the Nokia Contact Information section at
the front of this guide for instructions and a new boot manager.
The command to install the boot manager has the following syntax:
install_bootmgr boot-device boot-file
where boot-device is the storage device to which you write the new boot
manager image and from which boot manager image loads at boot up.
Boot-file is the new boot manager. The new boot manager options are
cpipflash
install_bootmgr
boot manager.
Note
To install the new boot manager, you must be in single-user mode.
To install the new boot manager
1. Start the appliance in single-user mode.
2. At the IPSO command prompt, enter:
/etc/install_bootmgr wd0 /image/current/bootmgr/
nkipflash
The command installs the new boot manager image (
flash device (
interrupt the installation process.
84
All manuals and user guides at all-guides.com
, ,
cpvpnflash nkipflash
command from IPSO (the operating system), not from the
). The installation takes some time to complete. Do not
wd0
, and . Execute the
nkvpnflash
IP350 and IP380 Appliance Installation Guide
) into the
nkipflash