Connecting Network Interfaces - Nokia IP350 Appliance Installation Manual

2
Installing the Appliance
The fan unit on the power supply turns on when you press the power switch.
Verify that the fans are running after you press the switch.
Check the power LED on the front panel of the appliance (the Nokia logo) to
ensure that the power supply is operating correctly. The power LED should be
illuminated. For more information about the system status LEDs, see
LEDs"
If the power supply fans are not running, or if the power LED is not
illuminated:
Check the power supply cord to make sure it is properly connected.
Make sure the power supply switch is on.
Make sure the chassis assembly is pushed all the way in from the front of
the platform.
Make sure that power is turned on to the power strip or wall receptacle
you plugged the appliance in to.
If the fans are still not running, or if the power LED does not illuminate,
contact your Nokia service provider as listed in
on page 3 for technical support.

Connecting Network Interfaces

Connect at least one network interface to the network to use as the Voyager
system management interface. This interface is configured during the system
startup procedure, which is described in
Configuration."
You can also connect the remaining LAN interface wires at this point,
although you are not required to do so.
To connect Ethernet devices:
Use a straight-through RJ-45 cable to connect to a 10-Mbps or
100-Mbps hub.
Use a crossover RJ-45 cable to connect directly to a host.
For details, see
30
All manuals and user guides at all-guides.com
on page 24.
"Ethernet NIC Connectors and Cables"
"Nokia Contact Information"
Chapter 3, "Performing the Initial
on page 50.
IP350 and IP380 Appliance Installation Guide
"Status