Installing The Boot Manager - Nokia IP300 Series Installation Manual

2. If the appliance is protected by a password, enter your current password.
The program prompts you for the new password.
3. Enter the new password.
The program prompts you to reenter the new password for verification.
4. Enter the new password again.
Note
If you forget your install password, contact the appropriate Nokia
Customer Support site as listed in
for information on how to set a new one.

Installing the Boot Manager

The boot manager is installed at the factory; you should not need to reinstall
it. If you should need to reinstall the boot manager, contact the appropriate
Nokia customer support site listed in the
page 3 for instructions and a new boot manager.
The command to install the boot manager has the following syntax:
install_bootmgr boot-device boot-file
where boot-device is the storage device to which you write the new boot
manager image and from which boot manager image loads at boot up.
Boot-file is the new boot manager. The new boot manager options are
cpipflash
install_bootmgr
boot manager.
Note
To install the new boot manager, you must be in single-user mode.
Nokia IP300 Series Security Platform Installation Guide
All manuals and user guides at all-guides.com
, ,
cpvpnflash nkipflash
command from IPSO (the operating system), not from the
Installing the Boot Manager
"Nokia Contact Information"
"Nokia Contact Information"
, and . Execute the
nkvpnflash
on page 3
on
91