Table of Contents
Advertisement
Table 4-7. Logic Analyzer Connector J13 Pin Assignments (continued)
Pin
7
8
9
10
11
12
13
14
M68MPB16R3UM/D
Mnemonic
DS
DATA STROBE – Active-low output signal. During a
read cycle, indicates that an external device should
place valid data on the data bus. During a write
cycle, indicates that valid data is on the data bus.
BR /
BUS REQUEST – Active-low input signal that
indicates an external device requires bus mastership.
CHIP SELECT 0 – Output signal that selects
CS0
peripheral or memory devices at programmed
addresses.
BG /
BUS GRANT – Active-low output signal that indicates
the MCU has relinquished the bus.
CSM
INTERNAL MODULE CHIP SELECT – Active-low
output signal that selects an external emulation
device at internally-mapped address.
CSBOOT
BOOT CHIP SELECT – An active-low output chip
select for external boot startup ROM
CLKOUT
SYSTEM CLOCK OUTPUT – MCU internal clock
output signal.
A23 /
ADDRESS BUS BIT 23 – One bit of the 24-bit
address bus.
CS10
CHIP SELECT 10 – Output signal that selects
peripheral or memory devices at programmed
addresses.
E
EXTERNAL CLOCK – M6800 bus clock output.
A22 /
ADDRESS BUS BIT 22 – One bit of the 24-bit
address bus.
CS9
CHIP SELECT 9 – Output signal that selects
peripheral or memory devices at programmed
addresses.
A21 /
ADDRESS BUS BIT 21 – One bit of the 24-bit
address bus.
CS8
CHIP SELECT 8 – Output signal that selects
peripheral or memory devices at programmed
addresses.
MEVB SUPPORT INFORMATION
Signal
4-7 7
Advertisement
Table of Contents
