ResMed AirFit P10 User Manual page 11


The technical specifications of the mask are provided for
your clinician to check that they are compatible with the
CPAP or bilevel device. If used outside specification or if
used with incompatible devices, the seal and comfort of the
mask may not be effective, optimum therapy may not be
achieved, and leak, or variation in the rate of leak, may affect
the CPAP or bilevel device function.

Discontinue using this mask if you have ANY adverse
reaction to the use of the mask, and consult your physician
or sleep therapist.

Using a mask may cause tooth, gum or jaw soreness or
aggravate an existing dental condition. If symptoms occur,
consult your physician or dentist.

As with all masks, some rebreathing may occur at low CPAP
pressures.

Refer to your CPAP or bilevel device manual for details on
settings and operational information.

Remove all packaging before using the mask.
Fitting
1. Hold the pillows away from your nose ensuring that the pillow
size (eg, M) with the left (L) and right (R) indicators are correctly
facing towards you then guide the nasal pillows into your nostrils
(L into your left nostril, R into your right nostril). Pull the headgear
over your head by holding the bottom strap and stretching it
around the back of your head. The top strap should sit
comfortably on top of your head.
Tip! There are raised logos on top of the frame so you can feel
the correct way up when fitting in the dark.
2. Move the mask away from your face then place it back to get a
comfortable fit. Ensure the nasal pillows fit securely into your
nostrils with both pillows positioned upright.
3. Finally, connect the end of the mask tubing into your device air
tubing. Your mask is now fitted and ready to use. When the
device is running, a light breeze should be felt through the vent.
To inspect the vent place a finger close but not over the entire
vent area.
English
3