Omron 3G8F5-DRM21 Operation Manual page 73

Creating and Editing Master Parameters
Slave Registration
1, 2, 3... 1. Select "Register Slave" from the top of the Create Master Parameters win-
dow.
a) Using Device List Data (Online or Offline)
When the device information has already been read to the device list
window from the actual network or a network configuration file, the
Slave information will be displayed in the registered Slave display area.
When necessary, register or remove Slaves as described in steps 2 and
3.
b) Without using Device List Data (Offline Only)
When there is no device information displayed in the device list window,
no Slaves will be displayed in the registered Slave display area. To allo-
cate memory for remote I/O, all of the Slaves must be registered as
described in step 2.
Note a) If a Slave is registered here, it isn't necessary to input the number
of I/O bytes occupied by the Slave when doing the I/O allocation.
b) The width of the columns in the registered Slave display area can
be adjusted just like the width of the columns in the device list dis-
play area. (The width of the first column can be changed too.)
2. Register Slaves as needed.
There are two ways to register Slaves: using registered Slave information
and inputting data into the Slave settings input area.
a) Registration Method 1: Using registered Slave information
This method is the fastest way to register the Slaves. It can also be used
for similar devices, such as two different models of a device made by the
same manufacturer.
i) Find another Slave in the registered Slave display area that is the
same model as the Slave to be registered. Click on that Slave's node
address.
That Slave's information will be displayed in the Slave setting input
area.
ii) Replace the node address with the new Slave's node address.
(Don't change any other settings.)
Section
Registered Slave display area
Slave settings input area
3-6
59