Sharp ER-A440 Service Manual page 77

After the execution of the procedure with the substitution of "2", treat EURO as domestic currency, and national
currency as foreign currency using Exchange 1 (
Since EURO becomes your domestic currency after execution of the procedure with the substitution of "2", you
must change unit prices in the each department and PLU to make prices correspond EURO before actually you
start operating your register again. As for the miscellaneous keys, also please change the rates or amounts so
that they are based on amounts in EURO.
When "3" is substituted to "A":
1.
Issuing a general Z1 report (Job #100)
2.
Issuing a general Z2 report (Job #200)
3.
Resetting GT1, GT2 and GT3
4.
Setting "No" for a PGM function "Printing exchange 1 total amount and change amount on receipt and
journal" (Job #2616)
5.
Setting "No" for a PGM function "Printing exchange 1 total amount on validation printing" (Job #2616) <only
for ER-A440>
6.
Setting "Multiplication" for a PGM function "Exchange 1 calculation method" (Job#2616)
7.
Changing the domestic currency symbol to the EURO symbol and setting the number of digits after decimal
of the domestic currency to 2
8.
Over-writing the currency description text of exchange 1 with spaces (Job #2334)
9.
Setting the round-off function enable for currency exchange
After the execution of the procedure with the substitution of "3", treat EURO as domestic currency.
When the operation with the substitution of "2" has been performed already, "3. Resetting GT1, GT2 and GT3"
is not executed.
Optional programming for the introduction of EURO
Programming relating with the function of exchange 1(
of Job #800 described in the previous section. After the execution on each period, conduct the following
programming depending on your needs.
Programming for Exchange 1 (
Currency exchange rate (Job #1310)
For the period 1 and period 2, set the EURO conversion rate.
For the programming details, please refer to your instruction manual.
Cheque/credit operation (Job #2616)
This programming is newly added for the introduction of EURO. Please refer to "Programming for optional
feature selection" on this leaflet.
Assigning the drawer number to the drawer for foreign currency (Job #2680)
It may be convenient to have two drawers for EURO (as domestic currency) and national currency (as the
foreign currency set in exchange 1) when both of these currencies are co-existing (period 2). In this case,
conduct this programming.
For the programming details, please refer to your instruction manual.
[
).
[
) cannot be changed automatically with the execution
[
)
PGM 1 PGM 2
3