Ornamental Ring A Or Barrier Assy Replacing Method; Installation - Sony DSC-WX50 Service Manual

Ver. 1.2 2012.03
The changed portions from
Ver. 1.1 are shown in blue.
1-7.

ORNAMENTAL RING A OR BARRIER ASSY REPLACING METHOD

Removal
Turn on the power switch and extend the lens (WIDE end).
1
Detach the battery.
2
Apply alcohol to two gaps A of the Ornamental Ring A with tweezers or a fine-tipped stick as shown below.
3
Turn the Ornamental Ring A clockwise and counterclockwise to detach it.
4
Note: As for the figure below, this model and the shape
of the main body are different.
Note:
下図は当機種と本体の形状が異なります。
Tweezers
A
Solvent
Disengage the four claws and remove the Barrier Assy.
5
Claws
Barrier Assy
Claws

Installation

Fit the four claws while inserting the Barrier Lever into the hole and attach the Barrier Assy.
1
Affix two Barrier Tapes to the Barrier Assy so that the end of each Barrier Tape touches the dent.
2
Note: The Barrier Tapes must not be wrinkled.
Barrier Assy Barrier
Lever
Claws Claws
Hole
Peel off the release papers of the Barrier Tapes.
3
Install the Ornamental Ring A and press it lightly.
4
Barrier Tapes
DSC-WX50_L2
Ornamental Ring A
Barrier Tape
Barrier Assy
Barrier Tape
Dent
Barrier Tape
Ornamental Ring A
1-8. OPTICAL STEPPING MOTOR (F1430) REPLACING METHOD
Removal
Remove the screw.
1
Unsolder the four locations of the Optical Stepping Motor (F1430) to detach it.
2
Solders
Screw
Optical Stepping
Motor (F1430)
Install
Solder the four locations of the Optical Stepping Motor (F1430).
1
Install the Optical Stepping Motor (F1430) with a screw.
2
*Tightening torque = 0.0xx ± 0.0xN • m (0.x ± 0.xkgf • cm)
Note:
Install the Optical Stepping Motor (F1430) while fitting the groove with the projection of worm.
Solders
Screw
Optical Stepping
Motor (F1430)
1-10
Projection
of worm
Groove