Barrier Assy Replacing Method - Sony DSC-W150 Service Manual

2-3. BARRIER ASSY REPLACING METHOD

Removal
1 Turn on the power switch and extend the lens up to the TELE end.
2 Detach the battery.
3 Insert the edge of nippers from the inner diameter into A or B of the Ornamental Ring (A) to make a cut in till the outside.
4 Pinch either of the parted surfaces and wind it up to peel the flat surface on the objective side.
Note: Applying a load to the lens barrel could affect the lens zoom-in operation. Do not apply a load to the lens barrel.
A
5 Utilizing a concave portion of the Barrier Assy, insert the edge of nippers into the side surface to make a cut in and wind it up
to peel about 2/3 (about 10mm; approximately second convex).
Note: Mask the second lens barrel to prevent damage.
6 Wind a rubber around the remaining part of the Ornamental Ring (A) and apply torque to peel the part that remains inside and
at the hem.
Rubber
7 Disengage three claws, and remove the Barrier Assy.
Claws
DSC-W150/W170_L2
B
Concave
Second lens barrel
Ornamental Ring (A)
Barrier Assy
Convex
10mm
2-6