Lens Block; Ornamental Ring (A) Or Barrier Block Assy Replacing Method - Sony ZV-1 Service Manual

4-3. Lens Block

4-3-1. Ornamental Ring (A) or Barrier Block Assy Replacing Method

Removal
1. Turn on the power switch and extend the lens (WIDE end).
2. Detach the battery.
3. Apply alcohol to the gap of the Ornamental Plate using tweezers or fine-tipped stick as shown below.
4. Detach the Ornamental Ring (A).
Note:
Do not turn the Ornamental Ring (A) because there is a
Positioning Boss. Detach the Ornamental Ring (A) in
the arrow direction.
Gap of Ornamental
Plate
5. Disengage the four claws and remove the Barrier Block Assy.
Claws
Barrier Block Assy
Installation
1. Fit the four claws while inserting the barrier lever into the hole and attach the Barrier Block Assy.
Barrier Block Assy
Claws
Claws
Note:
Ornamental Ring (A)は， 位置決めのボスがあるため，
左右にひねらず矢印方向に取り外してください。
Tweezers
Solvent
Boss
Claws
Barrier
Lever
Hole
Sony CONFIDENTIAL
For Authorized Servicer
Ornamental Ring (A)
67
SYS SET