Table of Contents
Advertisement
2-2. INITIALIZATION OF D, E, F PAGE DATA
1. Initializing the D,E,F Page Data
Note 1: If "Initializing the D, E, F Page Data" is performed,
all data of the D page, E page and F page will be
initialized. (It is impossible to initialize a single
page.)
Note 2: If the D,E,F page data has been initialized, "Modification
of D, E, F Page Data" and all adjustments need to be per-
formed again.
Note 3: < > : NTSC model (FCB-IX47/470)
[ ] : PAL model (FCB-IX47P/470P)
Adjusting page
Adjusting Address
Adjusting page
Adjusting Address
Adjusting page
Adjusting Address
Initializing Method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 2, address: 00, and set data: 55 <NTSC> or
data : 51 [PAL].
3) Select page: 2, address: 01, set data: 55<NTSC> or data : 51
[PAL], and press the PAUSE button of the adjusting remote com-
mander.
4) Select page: 2, address: 02, and check that the data is 01.
5) Select page: 3, address: 00, and set data: 29.
6) Select page: 3, address: 01, set data: 29, and press the PAUSE
button of the adjusting remote commander.
7) Select page: 0, address: 01, and set data: 00.
8) Perform "Modification of D,E,F Page Data".
FCB-IX47/47P
FCB-IX470/470P
D
00 to 6F
F
00 to FF
E
00 to FF
2. Modification of D, E, F Page Data
If the D, E, F page data has been initialized, change the data of the
"Fixed data-2" address shown in the following tables by manual
input.
Modifying Method:
1) Before changing the data, select page: 0, address: 01, and set
data: 01.
2) New data for changing are not shown in the tables because they
are different in destination. When changing the data, copy the
data built in the same model.
Note : If copy the data built in the different model, the camcorder
may not operate.
3) When changing the data, press the PAUSE button of the adjust-
ing remote commander each time when setting new data to write
the data in the non-volatile memory.
4) Check that the data of adjustment addresses is the initial value. If
not, change the data to the inital value.
5) After compleating "Modification of D, E, F Paga Data" select
page: 0, address: 01, and set data: 00. Also perform all adjust-
ments.
2-7 (E)
Advertisement
Table of Contents
