Man Overboard Procedures - Furuno 1933C Manual

OPERATIONAL SETUP
M a n O v e r b o a r d P r o c e d u r e
M a n O v e r b o a r d P r o c e d u r e
The MOB (Man Overboard) mark functions to mark man overboard position.
You can inscribe this mark from any mode, except while playing back data or
conducting any test.
Note: This function requires position data.
Press and hold down the [SAVE/MOB] key for about 3 seconds when someone
1
falls overboard.
Note: The display shows the waypoint number being saved (youngest empty
waypoint number, 001-999) followed by the MOB confirmation window.
Press the [ENTER] knob to select the MOB position as the destination, or press
2
the [CLEAR] key to only mark current ship's position as a waypoint.
Note: If you select the MOB position as destination or press [CLEAR] key to only
mark current ship's position as a waypoint, a full-screen radar, plotter, or overlay
appears depending on the left side of the display.
s
s
(cont.)
11