ResMed AirFit P10 User Manual page 8

2. Move the mask away from your face then place it back to get a
comfortable fit. Ensure the nasal pillows fit securely into your nostrils
with both pillows positioned upright.
3. Finally, connect the end of the mask tubing into your device air tubing.
Your mask is now fitted and ready to use. When the device is running,
a light breeze should be felt through the vent. To inspect the vent
place a finger close but not over the entire vent area.
Adjustment
To fix any mask leaks, adjust the headgear by pulling the headgear
through the buckle. Adjust only enough for a comfortable seal and do not
overtighten. You may need to adjust the headgear as it stretches over
time.
Removal
To take off your mask system, pull the mask and headgear by the split-
band, up and over your head.
Disassembly
1. Holding the top of the mask tubing, squeeze and pull the pillows away
from the mask frame.
2. Unhook the headgear from the stabiliser by pulling on the end cap to
reveal the buttonhole.
3. Slide the headgear off the end of the stabiliser.
Reassembly
1. With the grey side facing out, insert each end of the headgear band
over the stabilisers through the buttonholes. Secure in place by
wrapping each band end up and around the nodes. Holding the split
bands, pull the headgear from the stabiliser to ensure it is tightly
secure around the nodes. Ensure the headgear band is not twisted.
2. Attach the pillows to the mask frame by inserting the top and bottom
clips into the correct slots (shorter clip into top slot, longer clip into
bottom slot) on the mask frame. Your mask is now reassembled.
3. Ensure the inner walls of the nasal pillows are not compressed or
collapsed. If they are, squeeze each nasal pillow so they return to the
correct shape.
4