Table of Contents
Advertisement
d. Apply distortion to the output
Press the [DISTORTION] key.
Each time you press the key, distortion will be turned
on/off.
When this is on ([DISTORTION] key LED lit), distortion
will be applied. This is effective when you wish to pro-
duce a hard\ harsh tone.
If distortion is turned on, use the MIXER knobs to adjust
the degree of distortion.
If you adjust FILTER "Cutoff" or "Resonance," the char-
acter of the distortion will change.
e. Use keyboard playing dynamics to vary the volume
Press the SELECT [7] key, and then press the CURSOR
[®] key four times.
The LCD screen will show Page 09E: AMP "Vel Sense."
Use the [+/YES] [–/NO] keys to set the value.
Positive (+) values will cause the volume to increase as
you play more strongly.
Negative (–) values will cause the volume to decrease as
you play more strongly.
09E AMP
Vel Sense:
f. Vary the volume by the keyboard location you play
From the "Vel Sense" screen, press the CURSOR[®]
key.
The LCD screen will show Page 09F: AMP "KBD Track."
Use the [+/YES] [–/NO] keys to set the value.
Positive (+) values will cause the volume to increase as
you play upward on the keyboard, and decrease as you
play downward on the keyboard.
Negative (–) values will cause the volume to increase as
you play downward on the keyboard, and decrease as
you play upward on the keyboard.
09F AMP
KBD Track:
7. Specify time-variant changes in volume
EG 2 produces time-variant changes in the AMP "Level."
a. Adjust the speed at which the
+30
b. Adjust the speed at which the volume will decay
+25
c. Adjust the volume of the sustained sound
If you wish to use the front panel knobs to adjust the
EG 2 parameters, you must first use the SEQ EDIT
[SELECT] key to make the SEQ 1–3 LED's go dark.
Level
Note off
Note on
c
a
b
a: Attack Time
c: Sustain Level
b: Decay Time
d: Release Time
a
b
trigger
Rotate the EG 2 [ATTACK] knob.
The LCD screen will show Page 11A: EG 2 "Attack."
Rotating the knob toward the right (increasing the
value) will cause the sound to attack/ trigger more
slowly, and rotating it toward the left (decreasing the
value) will cause the sound to attack/ trigger instantly.
11A EG 2
Attack:
If rotating the knob does not produce an effect, make
sure that the AMP [EG 2/GATE] key LED is dark.
Rotate the EG 2 [DECAY] knob.
The LCD screen will show Page 11B: EG 2 "Decay."
Rotating the knob toward the right (increasing the
value) will cause a longer decay time until the sustain is
reached.
11B EG 2
Decay:
Rotate the EG 2 [SUSTAIN] knob.
The LCD screen will show Page 11C: EG 2 "Sustain."
Rotating the knob toward the right (increasing the
value) will produce a louder volume during the sustain.
11C EG 2
Sustain:
Basic Guide
time
d
c
d
will attack\
sound
000
021
090
23
Advertisement
Table of Contents
