Re)Placing The Rgb Input - Barco iCon H600 Installation Manual

3. (Re)placing the RGB input on iCon H600
Image 3-29
12.Remove the server or place the server on the side in case one must only access the PMP (input side screws)
Image 3-30
3.2

(Re)placing the RGB input

Following procedure shows how to replace the RGB input board on slot 1, the same must be done in case the
board is installed on any other slot.
Necessary tools
• Torx n°10
• small cross headed screwdriver
How to remove the RGB input board ?
1. Remove the front plates.
2. Loosen the input front screws and remove the plate.
18 R5976888 RGB/VIDEO INPUT KIT 30/07/2008