Components - Kenwood VR-9080 Instruction Manual

Audio video surround receiver
Hide thumbs Also See for VR-9080:
Table of Contents

Advertisement

Basic remote control operations for other components
Storing the remote control code of the other

components

The remote control unit can store the remote control code of the other
components and you can operate the other components from the remote
control unit. The remote control code is stored on the key or memory of
the remote control unit.
Storing on the key
You can store the remote control code to the key as shown below:
1
Point the infrared ray system part of another remote control
unit to the remote sensor of the remote control unit.
Receiving part
3 to 4 cm
(0.1 to 0.13 feet)
44
EN
Remote control
unit of the other
source.
Transmitting part
2
Press and hold the LEARN key for 3 seconds until
twice, then release the LEARN key.
3
Press the Numeric key to enter 9 , 7 , 5 .
4
Press any of the Source keys (DVD/6CH, VIDEO 1, VIDEO 2,
VIDEO 3, CD/DVD, PHONO, AV AUX, MD/TAPE, TV MODE) to
select the input of the desired remote control unit.
• While in Tuner mode, learning code function is not available.
5
Press the desired key of the remote control unit.
• "LEARN" and
appear on the display.
6
From the remote control unit of the other source, press the key
that you want to store.
• The remote control code is sent to the remote control unit.
• "OK" appears when finished.
• If the code cannot be stored after a few attempts, "ERROR" will
appear. Repeat from step 2 onwards.
7
The remote control code is stored on the key of this remote
control unit.
8
Repeat step 4 to 6 to store additional components until all
the desired components are stored.
9
To exit the learning mode, press and hold the LEARN key for
3 seconds until
blinks twice.
0
To clear the stored remote control code of the other sources:
1 Press and hold the LEARN key for 3 seconds until
twice, then release the LEARN key.
2 Press the Numeric key to enter
3 Press the Source key, then press the stored key twice until
blinks twice.
blinks twice to indicate that the stored remote control code are
deleted.
blinks
blinks
9 , 7 , 6 .

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Krf-x9090d

Table of Contents