Unpacking; Preparing The Remote Control - Kenwood VR-9080 Instruction Manual

Before applying the power

Unpacking

Unpack the unit carefully and make sure that all accessories are
present.
FM indoor antenna (1)
(For VR-9080)) (For KRF-X9090D)
Remote control unit (1)
RC-R0918
Microphone for SETUP (1)
(Cord length: approx. 5m (16 feet))
If any accessories are missing, or if the unit is damaged or fails to operate,
notify your dealer immediately. If the unit was shipped to you directly,
notify your shipper immediately. Kenwood recommends that you retain
the original carton and packing materials in case you need to move or ship
the unit in the future.
Keep this manual handy for future reference.
Channel space switching
(Except for the U.S.A., Canada and Australia)
The space between radio channels has been set to the one that
prevails in the area to which the system is shipped. However, if the
current channel space setting does not match the setting in the area
where the system is to be used, for instance when you move from
area 1 or area 2 shown in the following table or vice versa, proper
reception of AM/FM broadcasts cannot be expected. In this case,
change the channel space setting in accordance with your area by
referring to the following table.
Area
U.S.A., Canada and South
1.
American countries
2.
Other countries
50us 75us
AM 9kHz AM 10kHz
FM50kHz FM100kHz
DE-EMPHASIS
CHANNEL SPACE
Turn the power OFF by pressing the POWER key before moving the
switch level. Move the switch lever to match your area with a small
screwdriver or other pointed tool, then turn the power ON again.
4 EN
AM loop antenna (1)
Batteries (R03/AAA) (2)
*AC plug adapter (1)
(For KRF-X9090D)
*Use to adapt the plug on
the power cord to the shape
of the wall outlet.
(Accessory only for regions
where use is necessary.)
CHANNEL
Space Frequency
FM: 100 kHz
AM: 10 kHz
FM: 50 kHz
AM: 9 kHz

Preparing the remote control

Loading the batteries
1 Remove the cover.
3 Close the cover.
• Insert two AAA-size (R03) batteries as indicated by the polarity
markings.
Operation
When the standby indicator is lit, the power turns ON when you press the
RECEIVER ON key on the remote control. When the power comes ON,
press the key you want to operate.
Operating range
(Approx.)
6 m
(20 feet)
RECEIVER ON
• When pressing more than one remote control key successively, press
the keys securely by leaving an interval of 1 second or more between
keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause malfunction.
In such a case, change the location of the system installation to prevent
malfunction.
2 Insert the batteries.
Remote sensor
Infrared ray system