Table of Contents
Advertisement
THERM CONNECT
05
WOLF run around coil systems
05.04 Construction site transport of air handling units and assemblies
Caution!
Serious personal injury or property damage may result from falling loads if the safety instructions are not observed.
Use and observe the safety instructions for the means of transport, lifting gear and approved lifting gear (according
to BGV D6, Regulations of the employers' liability insurance association).
Do not stand under suspended loads!
Units without transport device: When transporting with a forklift or rollers, leave the transport pallet under the air
handling unit. When transporting with a forklift, ensure that the forks extend over the full width of the housing.
Frame must rest on forks on both sides.
The unit components may only be transported in the installed position. They must not be overturned or rotated in
the longitudinal axis, otherwise damage may occur to installed parts (e.g. fan vibration dampers shear off).
05.04.01 Fastening the load suspension brackets
Only the load suspension brackets specified or supplied
by the factory may be used to attach the suspension
ropes to the unit.
Attention! The use of the load suspension brackets
is only permitted for one device mounting!
The brackets must not be used for several devices, as pos-
sible hairline cracks could impair safety.
The load suspension brackets must be mounted using
hexagonal bolts DIN 933 M16 x 55 mm - 8.8 for stand-
ard design or hexagonal bolts DIN 933 M16 x 105 mm
- 8.8 for weatherproof design and washers 6.0 mm thick
with a minimum screw-in depth of 35 mm to ensure the
load capacity of the load suspension brackets.
The thread in the corner connector must not be dirty or
damaged.
For weatherproof units, use the spacer sleeves specified by the factory or supplied with the unit.
To fasten, align the lugs to the center (see illustration) and hand-tighten.
•
Load suspension brackets with missing markings must not be used.
•
Modifications and repairs, in particular welding, are not permitted.
•
Use for or of other manufacturers' products is not permitted.
8
Advertisement
Table of Contents
